Average Reviews:
(More customer reviews)I purchased this fender set to install on a TREK 4300.
The installation of the front fender was very easy, took no alterations of the mounting hardware and took less than 5 minutes.
The back fender required bending of the mounting bracket. The rear bracket is bent to a 90 degree angle and meant to mount to a rear facing threaded hole. My bike has the threaded hole pointing down toward the tire, so it required the bracket to be bent so that it was straight. It also appeared to require removal of the rear rim to get to the screw to install it. I did find that by letting the air out of the rear tire, I could get the screw mounted with a right angle screw driver (one of those small ones that have a bend on each end for reaching tight places).
In all, it only took about 15 minutes to bend the bracket and mount it, so the installation was still fairly easy.
The front fender is very stable, however because the rear fender is longer and only has one mounting point, it tended to slip out of alignment. I also mounted a Topeak rear rack on the bike, and I found that I could mount a small 90 degree angle bracket to one of the holes that was intended for a light, and then attach it to the rear of the fender. It now is very stable, however, it would be harder to remove. I leave my fenders on all of the time, so it doesn't create any problems for me.
Generally, I think the fenders are great and do an excellent job, even with the wide tires (2.00 x 26). I will mention that since the fenders are intended to work with either 26 or 28 inch tires, they are curved a little less than might be desired for a tight fit on the 26 inch tires. I heated them with a heat gun and found that I could bend them to a tighter curve, so that they fit the tires a little better.
Click Here to see more reviews about: SKS Beavertail Bicycle Fender Set (26 and 28-Inch Bikes)
Click here for more information about SKS Beavertail Bicycle Fender Set (26 and 28-Inch Bikes)
No comments:
Post a Comment